Market construction
Market construction

Harikafix harikafix

harikafix
Iran

HarikaFix block glue or gas block glue with German formulation is based on cement and polymer and contains special chemical or mineral substances to increase its adhesion and usability. This adhesive is suitable for installing all kinds of prefabricated and light concrete parts, such as Hablex block (gas block), AAC block, NAAC block, and CLC blocks that have high water absorption, as well as cement blocks and artificial and antique stones.
The above product conforms to the standard:
ASTM 1660-10 and the standard (BS EN 1052-3 (2007).
You can also make a price as a seller
Request a price to negotiate and get a better offer

Suppliers

SuppliersExpiration datePrice (Toman)Minimum order (MOQ)CityPhone number
The price is not recorded

similar products

Harikafix harikafix

Harikafix polymer gas block adhesive

Harikafix polymer gas block glue or Herikafix Hebelx glue with German formulation, is based on cement and polymer and contains special chemical and mineral substances to increase its adhesion and usability. This block adhesive is suitable for installing all kinds of prefabricated and light concrete parts, such as Hablex block (gas block), AAC block, NAAC block, CLC blocks, exposed brick and firebrick, which have high water absorption, as well as cement blocks and artificial and antique stones. is.

Uses of Heplex polymer block glue:
It replaces the usual traditional mortar, sand, cement, plaster and replaces plastering on light block parts
Filling the joints, repairing the damage of the light block parts, suitable for installing all kinds of bricks, Heplex blocks, Silex, light concrete, gas concrete, foam concrete, etc.

Advantages of Heplex polymer block glue:
No waste
No special chemical effects
unflamable
High adhesion to parts
Ready to use just by adding water
Reducing the extra load on the building

 


The physical state of Heplex polymer block glue:

White and gray polymer powder

 


Method and dosage:

Pour about 30% (6-7 liters) of the weight of the powder in clean water in a suitable container and add the powder little by little to mix to obtain a suitable paste. Wait a few minutes for the glue to set, then repeat

Stir the glue and add a little water if needed to get the desired concentration. Spread the glue on the desired surface using a special trowel and comb, note that the thickness of 2 to 3 mm of glue is enough, and more consumption will increase the cost. Now place the Haplex block on the Haricafix block adhesive and after adjusting its location, press it a little so that it completely sticks to the bottom layer. The consumption of this adhesive is about 20 kg per cubic meter. To get a better result, it is recommended to sand the blocks before installation. This glue has high stability and can be used for up to 2 hours, so its waste is zero and completely affordable.

Product Specifications

Weight (cm3)
1.4
Compressive strength (kg / cm2)
More than 350
Average shear adhesion strength (N/mm2)
6/8

User's comments and scores